Model: R50-10T4-FSI-0.05

   HIWIN high-load screw R50-10T4-FSI-0.05, screw outer diameter 50mm, lead 10mm, nut internal circulation structure, iron material circulator, using 6.35 outer diameter high-hardness steel balls, is a good choice for heavy load and high drive .

R50-10T4-FSI-0.05 dimension drawing

Details of rust method on silver wire rod R50-10T4-FSI-0.05

     Anti-rust upper silver rod
1. Surface pretreatment of the anti-rust object: 1.Surface cleaning: Cleaning must be carried out according to the nature of the surface of the anti-rust object and the current conditions, and an appropriate method must be selected. Commonly used are solvent cleaning method, chemical treatment cleaning method and mechanical cleaning method; 2. After the surface is dry and cleaned, it can be dried with filtered dry compressed air, or dried with a dryer at 120~170 ° C, or dried with clean gauze .

     Introduction to rust prevention methods
The main factors affecting metal corrosion: Metal corrosion is caused by various internal and external factors, which can be summarized as follows: 1.The chemical composition and structure of the metal material itself; 2.Metal surface finish (battery corrosion due to oxygen concentration difference); 3.The composition and pH value of the solution in contact with the metal surface; 4.Ambient temperature and humidity; 5.Various environmental media in contact with the metal surface.
the
Second, apply anti-rust oil:

      1. The brushing method is used for outdoor construction equipment or special-shaped products that are not suitable for soaking or spraying. When brushing the silver rod, pay attention not only to avoid accumulation, but also to prevent leakage.

      2. Soaking method: Some small items are soaked in anti-rust grease, and a layer of anti-rust grease is attached to the surface. The thickness of the oil film can be achieved by controlling the temperature or viscosity of the anti-rust grease;

      3. Spray method Some large anti-rust objects cannot be oiled by immersion method. Generally, filter compressed air with a pressure of about 0.7Mpa is used to spray in clean air. The spray method is suitable for solvent-diluted anti-rust oil or thin-layer anti-rust oil, but perfect fire prevention and labor protection measures must be adopted;